REAR OFFSIDE/RIGHT LIGHT CLUSTER LENS

Product Information

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i)) Original design characteristics and specialised modifications (e.g. to enable wheelchair access, or changed to a fixed seat) are to be accepted. Defect On vehicles first used on or after 1 September 1965 with direction indicators combined with position lamps, the position lamp may or may not go out when its direction indicator is flashing. The direction indicator must flash amber only, with no white or red light. Buses first used before 1 October 1969 only need one headlamp. If 2 are fitted, neither the main beam or dipped beams need to form matched pair. This has different brakes to yours (upper ends), but the basics are the same. The front mounts are on the lower legs.

Vehicles first used before 1 January 1971 can be fitted with only one stop lamp. The lamp can be mounted centrally or towards the offside. Towbar mounting points are not prescribed areas and the vehicle structure should only be rejected if its strength or continuity is significantly reduced.

In addition to the MOT question, consider that you're talking about properly structural rot. Seat and seatbelt mounts, suspension mounts, pedal mounts. If the worst happens, that kind of bodge-weld has no structural integrity to it whatsoever. Buses first used before 1 October 1969 only need one headlamp. If 2 are fitted, neither the main beam or dipped beams need to be a matched pair. Only fail a vehicle for missing heat shields if there’s a risk of fire with other fuel system components. Defect Press the brake pedal to light up the stop lamps and operate all the other lamps in turn to see if the stop lamps are adversely affected. Defect

Vehicles first used before 1 January 1971 can be fitted with only 1 stop lamp. The lamp can be mounted centrally or towards the offside.

Turning nearside to nearside

You must inspect all types of coupling mechanisms and towbars fitted to the rear of a vehicle, including fifth-wheel couplings. a) Switch does not operate in accordance with the requirements or the rear position lamps can be switched off when the headlamps are on